![]() ![]() The equipment shall react within 12 ms by issuing AIS.Īlthough E1s don’t use the terms YELLOW, BLUE, RED, they are for comparisons with T1. RED: Loss of signal (LOS): The equipment shall assume “loss of signal” when the incoming signal amplitude is, for a time duration of at least 1 ms, more than 20 dB below the nominal amplitude. ![]() AIS is non-framed and coded as all binary ONEs. RAI/Yellow received (Remote Alarm Indication - from remote NT) RED Loss of. A characteristic of AIS is that its presence indicates that the timing provided to the TE may not be the network clock. The Primary Rate system is incorporated in the Fivemere SBU6C, or SBU14C. BLUE: alarm indication signal (AIS): The AIS (alarm indication signal) is used to indicate loss of layer 1 capability in the ET-to-TE direction on the network side of the user-network interface.RAI propagates towards the network if layer 1 capability is lost in the direction of the user, and RAI propagates toward the user if layer 1 capability is lost in the direction of the network. YELLOW: remote alarm indication (RAI): The RAI (remote alarm indication) signal indicates loss of layer 1 capability at the user-network interface.The PRI configuration is based on T-carrier or T1 in the US, Canada and Japan countries consisting of 23 data or bearer channels and one control or delta channel, with 64kbps speed for a bandwidth of 1.544 M bits/sec. The Alarm Control Unit is designed to be used as a remote interface on a network of up to. Primary Rate Interface (PRI) The Primary Rate Interface or Primary Rate Access, simply called the ISDN PRI connection is used by enterprises and offices. Security Analog trunk lines are a breeze to tap into without any technical knowledge. For use with Smart RF Smoke, Heat and Carbon Monoxide Alarms. They are also digital which makes troubleshooting any issues easy and efficient compared to analog trunk lines. E1 is a the European equivalent of a T1 but runs at 2.048Mbps and has 32 x 64Kbps channels DS0s where 30 is used for voice and two are used for syncronization and signaling. Primary Rate Interface lines provide stability by being powered from the central office which allows them to stay up during power failures.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |